Finned tubes provide better heating efficiency
Known as the boiler, it is most of the time we use, the boiler with finned tube is mainly used for heat transfer, so whether the boiler finned tube fin, the more the better, the answer is no.
When the heat transfer area of finned tube used in our boiler is doubled, the heat transfer coefficient cannot be doubled, but a discount, usually (0.9-- 0.7), and the higher the fin, the greater the discount value, even reduced to (0.5) below. After the appeal, we can know that the higher the fin, the lower the use efficiency will be, so the production cost of finned tube for each boiler is increased, but its use effect is not increased, so it is not cost-effective.
Murphy heat technology laser welded stainless steel finned tube design is mainly to improve the heat exchange efficiency and do the product, finned tube usually in the surface of the heat exchange tube by adding fins, increase the surface area of the heat exchange tube (or internal surface area), through this way, it can improve the purpose of heat exchange efficiency. Finned tube is a spiral groove with a certain width and depth preprocessed on the steel tube, and then the steel strip is inlaid on the steel tube on the lathe.
By means of winding, the laser-welded finned tube coil has a certain pre-tightening force, so that the steel belt will be tightly locked in the spiral groove, thus ensuring a certain contact area between the steel belt and the steel pipe. To prevent the strip from falling off, the two ends of the strip should be welded to the steel pipe. In order to facilitate the inlay, there should be a certain side gap between the steel strip and the spiral groove, which can bring better heating efficiency.
When the heat transfer area of finned tube used in our boiler is doubled, the heat transfer coefficient cannot be doubled, but a discount, usually (0.9-- 0.7), and the higher the fin, the greater the discount value, even reduced to (0.5) below. After the appeal, we can know that the higher the fin, the lower the use efficiency will be, so the production cost of finned tube for each boiler is increased, but its use effect is not increased, so it is not cost-effective.
Murphy heat technology laser welded stainless steel finned tube design is mainly to improve the heat exchange efficiency and do the product, finned tube usually in the surface of the heat exchange tube by adding fins, increase the surface area of the heat exchange tube (or internal surface area), through this way, it can improve the purpose of heat exchange efficiency. Finned tube is a spiral groove with a certain width and depth preprocessed on the steel tube, and then the steel strip is inlaid on the steel tube on the lathe.
By means of winding, the laser-welded finned tube coil has a certain pre-tightening force, so that the steel belt will be tightly locked in the spiral groove, thus ensuring a certain contact area between the steel belt and the steel pipe. To prevent the strip from falling off, the two ends of the strip should be welded to the steel pipe. In order to facilitate the inlay, there should be a certain side gap between the steel strip and the spiral groove, which can bring better heating efficiency.
评论
发表评论