Sealing groove used in spiral plate heat exchanger equipment
Spiral plate heat exchanger devices used by the plate on both sides of seal groove, of course, there will be a continuous distribution side, and, in general, actually a side is straight, the other side also is irregular corrugated side. The continuous side edge in the center will provide strong support to the gasket, but the corrugated side edge of the plate and the corrugated side edge of the gasket will also realize just biting each other, which will make the gasket more firmly fixed on the plate, not easy to slide out of the seal groove due to pressure fluctuations and other reasons.
The plate used in the helical plate heat exchanger equipment, Murphy experts use new technology and make non-bonding gasket appears to be very easy to install, and the ridgelike projection on the outside of the gasket just matches the groove on the back of the other plate, so that the whole plate group can get stuck when clamping to avoid dislocation.
Spiral plate heat exchanger equipment in the use of special adhesive and high temperature curing bonding process. In the same industry, the high temperature curing and bonding process is adopted. The sealing adhesive will choose special products produced by 3M company in the United States according to the water quality characteristics, and then it will use the supporting glue coating equipment to spray the adhesive.
In this way, to a large extent, it can guarantee the bonding stability of the sealing gasket of the spiral plate heat exchanger and the service life of the sealing gasket. After the bonding of the plate and the sealing gasket, under certain preloading conditions, it is necessary to pay attention to the need to be put into a 160℃ high temperature oven to dry for 8 hours at a constant temperature.
At this time of the spiral plate heat exchanger on the plate and the sealing gasket also occurs between high temperature of polymerization, which in turn makes the plate and sealing gasket glue more solid, it is because of this, the assembly after the spiral plate heat exchanger plate of the operating mode of under 160 ℃ after repeatedly disassembling, will its sealing gasket will not appear fall off phenomenon.
The plate used in the helical plate heat exchanger equipment, Murphy experts use new technology and make non-bonding gasket appears to be very easy to install, and the ridgelike projection on the outside of the gasket just matches the groove on the back of the other plate, so that the whole plate group can get stuck when clamping to avoid dislocation.
Spiral plate heat exchanger equipment in the use of special adhesive and high temperature curing bonding process. In the same industry, the high temperature curing and bonding process is adopted. The sealing adhesive will choose special products produced by 3M company in the United States according to the water quality characteristics, and then it will use the supporting glue coating equipment to spray the adhesive.
In this way, to a large extent, it can guarantee the bonding stability of the sealing gasket of the spiral plate heat exchanger and the service life of the sealing gasket. After the bonding of the plate and the sealing gasket, under certain preloading conditions, it is necessary to pay attention to the need to be put into a 160℃ high temperature oven to dry for 8 hours at a constant temperature.
At this time of the spiral plate heat exchanger on the plate and the sealing gasket also occurs between high temperature of polymerization, which in turn makes the plate and sealing gasket glue more solid, it is because of this, the assembly after the spiral plate heat exchanger plate of the operating mode of under 160 ℃ after repeatedly disassembling, will its sealing gasket will not appear fall off phenomenon.
评论
发表评论